Solved: Switch Xy Direction

1. Solved: Switch Xy Directions

The problem statement, all variables and given/known data You are walking on the graph of ##f(x,y) = y cos( pi x) - x cos( pi y) + 10##, standing at the point ##(2,1,13)##. Find an x, y-direction you should walk in to stay at the same level. Relevant equations ##D_u f = nabla cdot. Block Diagram of TLE4966K/L and TLE4966-3K double Hall Sensor with direction detection. The distance of the Hall elements on the chip is 1.45mm. Speed & Direction Sensor TLE4966 Hall-Effect Index Counting Switch with Direction Detection.

Solved: Switch Xy Directions

I started this week building my XY Plotter v2, first I want to get everything working correctly with a pencil, and then try using the Laser engraver module which I also ordered. Since I’m having some problems getting the plotter to draw what I want (see this topic), while I was waiting for a good answer on that topic, I decided to go ahead and install the laser module already. Now I have it installed as per the instructions, however I see a problem: The laser is mounted low enough so it will make contact with the top bar of the frame (the opposite bar of the one where the Y-axis motor and control board are mounted). And since it sticks out a couple of centimetres the laser module would actually hit the frame before triggering the limit switch 2. I would assume I need to put the laser higher so it doesn’t hit the beam of the frame, but it doesn’t say that in the installation manual Here some pictures to clarify what I mean.